Command control, Control command via lan, When [lan control protocol] is set to [protocol 1 – Panasonic TH-65SQ1WA 65" Class 4K HDR Commercial Monitor User Manual
Page 93
93
English
Other
●
This device is compatible with Panasonic devices that
support DIGITAL LINK output (ET-YFB100G, ET-
YFB200G). For the twisted pair cable transmitter of
other manufacturers, see the web site.
(https://panasonic.net/cns/prodisplays/solutions/
technology/digital_link/compatible_equipment/)
●
Panasonic has tested other manufacturers’ devices
according to our check items. This will not guarantee
all the operations. For operation and performance
defects caused by other manufacturers’ devices,
contact each manufacturer.
Command control
Network function of the unit can control the unit in the
same way as serial control from a network.
Supported commands
Commands used in the serial control are supported.
(see page 29)
Control Command via LAN
The communication differs whether [Setup] - [Network
settings] - [LAN control protocol] is set to [Protocol 1] or
[Protocol 2].
1. When [LAN control protocol] is set
to [Protocol 1].
Communicates using the display-specific protocol.
■
When the WEB control administrator
privileges password has been set (Protect
mode)
Connection method
1
Obtain the display’s IP address and the port number
(Default is 1024), and request connection to the
display.
The IP address and the port number can be obtained
from the following menus.
•
IP address:
[Setup
] → [
Network settings
] → [
LAN setup] or
[Network status]
•
Port number:
[Setup
] → [
Network settings
] → [
LAN setup]
●
For more detail of the settings, see page 78.
2
The display responds.
Response data
Data part Space Mode Space
Random
number
part
Last
terminal
symbol
[PDPCONTROL]
(ASCII
character
string)
[ ]
0x20
[1]
0x31
[ ]
0x20
[zzzzzzzz]
(ASCII
code hex
number)
(CR)
0x0d
10 bytes 1 byte 1 byte 1 byte 8 bytes 1 byte
Mode: 1 = Protect mode