Roland SP-404MKII Creative Sampler and Effector - Manual (Page 94)

Mixing the Samples (DJ MODE)
94
Editing a Sample in DJ Mode
You can edit the samples that are used in DJ mode.
1. Press the [VALUE] knob.
A menu appears.
2. Use the [VALUE] knob to select “CH1 EDIT” or “CH2 EDIT,” and press the [VALUE] knob.
The sample edit screen appears. The editing method is the same as for sample edit in sample mode.
Controller Action
[CTRL 1] knob Moves the start point.
[CTRL 2] knob (when the
loop is on)
Moves the loop point.
[CTRL 3] knob Moves the end point.
[SHIFT] button + [CTRL]
knob (turn)
Zooms the area around each point in/out.
[VALUE] knob (turn) Zooms the area in/out around each point you just manipulated.
[VALUE] knob (press) You can use a numerical value to set the position of each point.
Use the [VALUE] knob to select the point to set, and press pads [1]–[10] to input the
position (press pad [10] to input a “0”).
To confirm the inputted position, press the [VALUE] knob.
[SHIFT] button + [VALUE]
knob (turn)
Adjusts the volume of the channel.
[DEL] button Initializes the start and end point positions.
●
When a confirmation message appears, use the [VALUE] knob to select “OK,” and
press the [VALUE] knob.
[REMAIN] button On: Prevents the start point from being moved beyond the loop point or the end point.
Off: When the start point moves beyond the loop point or the end point, this moves the
loop point or the end point as well.
[ROLL] button While this button is pressed, you can preview the sound several seconds before the end
point.