Roland SP-404MKII Creative Sampler and Effector - Manual (Page 135)

Appendix
135
Parameter Value Explanation
MODE
JUNO 1, JUNO 2, JUNO12, JX-1 1,
JX-1 2
Sets the type of effect.
NOISE 0–100 Adjusts the volume of noise generated by the effect.
BALANCE 100-0–0-100 (%)
Adjusts the volume balance between dry (the original sound) and effect
sound.
Flanger
This effect creates modulation like a jet airplane taking off and landing.
Parameter Value Explanation
DEPTH 0–100 Sets the depth of the effect sound.
RATE
0–100 (when the SYNC parameter is OFF)
4.000–0.016 (bars; when the SYNC
parameter is ON)
Sets the cycle (period) of the effect sound.
MANUAL
0–100 Sets the frequency range in which the effect is applied.
Smaller values reduce the flanging effect in the low end.
RESONANCE
0–100 Adjusts the filter’s resonance level.
Increasing the value further emphasizes the effect, for a more
unusual sound.
BALANCE
100-0–0-100 (%) Adjusts the volume balance between dry (the original sound)
and effect sound.
SYNC OFF, ON When this is ON, the effect sound synchronizes with the tempo.
Phaser
This effect creates modulation by adding a phase-shifted sound.
Parameter Value Explanation
DEPTH 0–100 Sets the depth of the effect sound.
RATE
0–100 (when the SYNC parameter is OFF)
4.000–0.016 (bars; when the SYNC
parameter is ON)
Sets the cycle (period) of the effect sound.
MANUAL
0–100 Sets the frequency range in which the effect is applied.
Larger values reduce the phasing effect in the low end.
RESONANCE
0–100 Adjusts the filter’s resonance level.
Increasing the value further emphasizes the effect, for a more
unusual sound.
BALANCE
100-0–0-100 (%) Adjusts the volume balance between dry (the original sound)
and effect sound.
SYNC OFF, ON When this is ON, the effect sound synchronizes with the tempo.
Wah
This effect gives a wah-wah sound, by cyclically changing the tone.
Parameter Value Explanation
PEAK
0–100 Larger values narrow the frequency range at which the effect
is applied.
RATE
0–100 (when the SYNC parameter is OFF)
1.000–0.010 (bars; when the SYNC parameter
is ON)
Sets the cycle (period) of the effect.
MANUAL 0–100 Sets the frequency range in which the effect is applied.
DEPTH 0–100 Sets the depth of the effect.
FLT TYPE
Sets the filter type.
LPF Applies the effect over a wide frequency range.
BPF Applies the effect over a narrow frequency range.
SYNC
OFF, ON When this is ON, the effect sound synchronizes with the
tempo.