Roland SP-404MKII Creative Sampler and Effector - Manual (Page 134)

Appendix
134
Cassette Sim
This effect simulates the sound of a cassette tape playing.
Parameter Value Explanation
TONE 0–100 Sets the tone.
HISS 0–100 Adjusts the volume of the noise.
AGE 0–60 (years) Sets how many years the cassette tape has deteriorated.
DRIVE 0–100 Adjusts the amount of distortion.
WOW FLUT 0–100 Sets the inconsistencies (wow/flutter) heard when the cassette tape plays back.
CATCH 0–100 Sets how much the cassette tape has stretched out.
Lo-fi
Degrades the tonal character.
Parameter Value Explanation
PRE FILT
1–6 Sets the type of pre-filter (the filter that the sound passes
through before effects are applied).
LOFI TYPE 1–9 Larger settings cause more tonal degradation.
TONE
-100–100 Sets the tone. Larger settings emphasize the high-frequency
range. Smaller settings emphasize the low-frequency range.
CUTOFF
200, 250, 315, 400, 500, 630, 800, 1000, 1250,
1600, 2000, 2500, 3150, 4000, 5000, 6300,
8000 (Hz)
Sets the frequency range in which the post-filter (the filter
that the sound passes through after effects are applied)
works.
BALANCE 100-0–0-100
Adjusts the volume balance between dry (the original sound)
and effect sound.
LEVEL 0–100 Adjusts the volume of the effect sound.
This effect may output a very loud sound, depending on how the parameters are set. Use caution not to raise the values too
much.
Reverb
Adds reverberation to the sound.
Parameter Value Explanation
TYPE AMBI, ROOM, HALL1, HALL2 Sets the type of reverb.
TIME 0–100 Sets the reverb time.
LEVEL 0–100 Adjusts the volume of the effect sound.
LOW CUT FLAT, 20–800 (Hz) Sets the frequency range at which the effect sound is attenuated.
HIGH CUT 630–12500, FLAT (Hz)
PRE DELAY 0–100 (ms) Sets the time before the effect sound is output.
Chorus
Adds spaciousness and richness to the sound.
Parameter Value Explanation
DEPTH 0–100 Sets the depth of the effect sound.
RATE 0.33–2.30 (sec) Sets the cycle (period) of the effect sound.
BALANCE 100-0–0-100 (%) Adjusts the volume balance between dry (the original sound) and effect sound.
EQ LOW -15–15 (dB) Adjusts the amount of boost/cut of the low-frequency range.
EQ HIGH -15–15 (dB) Adjusts the amount of boost/cut of the high-frequency range.
LEVEL 0–100 Adjusts the volume of the effect sound.
JUNO Chorus
This effect models the chorus section of the Roland JUNO-106 and JX series.