Roland SP-404MKII Creative Sampler and Effector - Manual (Page 140)

Appendix
140
Parameter Value Explanation
For note messages (Note Number = 0–127) and pitch bend messages, set the
MIDI channel on your external device to “11”.
FORMANT -100–100
Adjusts the formant of the voice. Lower settings give a more masculine vocal
character, and higher settings give a more feminine vocal character.
TONE -100–100 Adjusts the brightness of the effect sound.
SCALE C maj–B maj, C min–B min Sets the scale to use and its root.
CHORD
Root, P5, Oct, UpDn,
UpDnP5, 3rd, 5thUp,
5thDn, 7thUp, 7thDn
Sets the chord structure.
BALANCE 100-0–0-100 Adjusts the volume balance between dry (the original sound) and effect sound.
Harmony
This effect adds a harmony to your voice.
Parameter Value Explanation
PITCH
-100–100 Sets the pitch of the voice. You can change the pitch up and down
one octave.
FORMANT
-100–100 Sets the formant of the voice.
Lower settings give a more masculine vocal character, and higher
settings give a more feminine vocal character.
BALANCE 100-0–0-100 (%)
Adjusts the volume balance between the dry (original) sound and
effect sound.
AT PITCH 0–100 Adjusts the strength at which the pitch is corrected.
KEY
CHROMA, A, B ³ , B, C, D ³ , D, E ³ , E, F, G ³ ,
G, A ³
Sets the key to which the pitch is adjusted and the harmonies are
added.
HARMONY Root, P5, Oct, UpDn, UpDnP5, 3rd,
5thUp, 5thDn, 7thUp, 7thDn
Sets the harmonization.
Gt Amp Sim
This effect models a guitar amplifier.
* This is enabled with INPUT FX.
Parameter Value Explanation
AMP TYPE
Selects the guitar amp type.
JC Models the sound of a Roland JC-120.
TWIN Models a Fender Twin Reverb.
BG Models a lead guitar sound played using a MESA/Boogie combo amp.
MATCH Models a Matchless D/C-30.
MS Models a Marshall 1959.
SLDN Models a Soldano SLO-100.
DRIVE 0–100 Adjusts the volume and distortion of the amp.
LEVEL 0–100 Adjusts the volume of the effect sound.
BASS -100–100 Adjusts the low-frequency tonal character.
MIDDLE -100–100 Adjusts the midrange tonal character.
TREBLE -100–100 Adjusts the high-frequency tonal character.
Control change messages and corresponding effects
You can use a control change message (CC#83) to select the effects.
The effects (selectable effects) corresponding to the respective CC#83 values are shown below.
BUS1 (MIDI ch 1), BUS2 (MIDI ch 2)
Value of CC#83 Effect name
0 (OFF)
1 Direct FX1