Midi, Midi-related settings, Visual control settings – Roland HandSonic HPD-20 Digital Hand Percussion Instrument User Manual
Page 66: Ibed in “midi-related settings” (p. 66), and assig

SYS
66
MIDI
MIDI
MENU
g
SYS
g
MIDI
g
MIDI
Parameter
Explanation
MIDI-related settings
Here you can make settings such as MIDI channel and control change numbers.
MIDI Channel
Specifies the transmit and receive channels. The default value is “10.”
Local Control
If this is “OFF,” the HandSonic’s pads will be disconnected from its internal sound generator.
Normally you’ll leave this “ON.”
The default value is “ON.”
Note Chase
If this is “ON,” note messages received via MIDI or USB MIDI will switch the pad selected for editing.
The default value is “ON.”
D-BEAM CC#
Specifies the control change number that is transmitted when you position your hand above the D-BEAM.
The default value is “GENERAL6(81).”
Realtime Modify
Pitch CC#
Specifies the control change number that is transmitted when you press the [PITCH] button and turn the realtime
modify knob.
The default value is “PITCH BEND.”
Realtime Modify
Effect CC#
Specifies the control change number that is transmitted when you press the [EFFECT] button and turn the realtime
modify knob.
The default value is “GENERAL7(82).”
Program Change Tx
If this is “ON,” a program change message will be transmitted when you switch kits.
The default value is “OFF.”
Program Change Rx
If this is “ON,” incoming program change messages will switch kits.
The default value is “OFF.”
Control Change Tx
If this is “ON,” control change messages will be transmitted.
The default value is “ON.”
Control Change Rx
If this is “ON,” control change messages will be received to modify the sound.
The default value is “ON.”
Pressure Tx
If this is “ON,” polyphonic aftertouch messages will be transmitted when you press down on a pad.
The default value is “ON.”
Pressure Rx
If this is “ON,” polyphonic aftertouch messages will be received to modify the sound.
The default value is “ON.”
MIDI VISUAL CONTROL
MENU
g
SYS
g
MIDI
g
VISUAL
Parameter
Explanation
Visual control settings
MIDI Visual Control is a function that lets you control images along with your performance (p. 67).
If you’ve set Control Mode to “MVC” or “V-LINK,” playing pads of the HandSonic will control the images produced by the Visual device
connected to the HandSonic.
MIDI Visual Control
Turn this “ON” if you want to control a video device (sold separately) in synchronization with your performance.
When you turn the power on, this will always be “OFF.”
Control Mode
Set this as appropriate for the video device that’s connected.
MIDI Channel
Specifies the MIDI channel used to switch images.
The default value is “16.”
Knob CC#
Specifies the control change number that is transmitted when you turn the realtime modify knob.
The default value is “74.”