beautypg.com

Inst, Assign an instrument (inst), Adjusting the volume (volume) – Roland HandSonic HPD-20 Digital Hand Percussion Instrument User Manual

Page 46: Adjusting the pitch (tuning), Varying the pitch (sweep), Adjusting the length of the sound (muffling), Adjusting the tonal character (color), Applying effects, Adjusting the left/right position of the sound, Pan)

background image

46

INST

INST

MENU

g

INST

g

INST

These settings are made for each pad.

Parameter

Explanation

Assign an instrument (Inst)

Inst A

Assign instrument A or instrument B. Choose “OFF” if you don’t want sound to be produced.
Press the [ENTER] button to see the instrument list.

Inst B

INST–EDIT

MENU

g

INST

g

EDIT

These settings are made separately for instruments A and B.

Parameter

Explanation

Adjusting the volume (Volume)

Volume

Adjusts the volume.

Adjusting the pitch (Tuning)

Tuning

Adjusts the pitch. Positive (“+”) settings raise the pitch, and negative (“-”) settings lower the pitch.

The units are cents; 100 cents = one semitone.

Varying the pitch (Sweep)

Sweep

Sweeps the pitch upward (or downward).

With positive (“+”) settings, the pitch starts high and sweeps down; with negative (“-”) settings, the pitch starts low

and sweeps up. Greater values produce greater change.
* In some cases, large changes in “Tuning” may limit the “Sweep” effect.

Adjusting the length of the sound (Muffling)

Muffling

Greater values reduce the decay, emphasizing the attack.

Adjusting the tonal character (Color)

Color

Adjusts the brightness of the sound.

Positive (“+”) settings brighten the sound, and negative (“-”) settings darken the sound.

Adjusting the left/right position of the sound (Pan)

Pan

Adjusts the left/right position. “CTR” is center.

Applying effects

Amb Send

This is the same parameter as “AMBIENCE SEND–PAD” (p. 52).

MFX Asgn

This is the same parameter as “MULTI-FX–ASSIGN” (p. 51).

Listening to only instrument A or B

By striking a pad while you hold down the [SHIFT] button, you can listen to only instrument A or B, depending

on the position of the cursor. Even if the sound of instruments A and B are being layered, this allows you to make

adjustments while listening to them separately.

Applying the same values to all pads (ALL)

If you hold down the [SHIFT] button and press the [ENTER] button, the value of the selected parameter will be

copied to all pads.