Nikon D500 User Manual
Page 356
330
1 Not available with spot metering.
2 Can also be selected with flash unit.
3
qA/A mode selection performed on flash unit using custom settings. Unless lens data have
been provided using the
Non-CPU lens data option in the setup menu, “A” will be
selected when a non-CPU lens is used.
4 Unless lens data have been provided using the
Non-CPU lens data option in the setup
menu, non-TTL auto will be selected when a non-CPU lens is used.
5 Can only be selected with camera.
6 Available only during close-up photography.
7 Unless lens data have been provided using the
Non-CPU lens data option in the setup
menu, non-TTL auto (A) is used with non-CPU lenses, regardless of mode selected with flash
unit.
8 Choice of
qA and A depends on the option selected with master flash.
9 Supports the same features as remote flash units with optical AWL.
10 Available only in i-TTL,
qA, A, GN, and M flash-control modes.
11 Available only in i-TTL flash control mode or when flash is set to emit monitor pre-flashes in
qA or A flash control mode.
12 Available only in commander mode.
13 Firmware updates for the SB-910 and SB-900 can be performed from the camera.
Auto FP High-Speed Sync
10
✔
✔
✔ ✔ ✔ ✔ ✔ — —
FV lock
11
✔
✔
✔ ✔ ✔ ✔ ✔ ✔ ✔
AF-assist for multi-area AF
✔
✔
✔ ✔ — ✔
12
—
—
—
Red-eye reduction
✔
✔
✔ ✔ ✔ — — ✔ —
Camera modeling illumination
✔
✔
✔ ✔ ✔ ✔ ✔ — —
Unified flash control
✔
—
—
—
✔ — — ✔ ✔
Camera flash unit firmware update
✔ ✔
13
✔ — ✔ — — — ✔
SB-5
000
SB
-910, S
B
-900,
SB
-800
SB
-700
SB
-600
SB
-500
SU
-800
SB-R
200
SB
-400
SB
-300