Nikon D500 - Manual (Page 104)

78
❚❚ Ending Shooting
To end shooting before all the photos are taken, highlight Off in
the time-lapse movie menu and press
J, or press J between
frames or immediately after a frame is recorded. A movie will be
created from the frames shot to the point where shooting
ended. Note that shooting will end and no movie will be
recorded if the power source is removed or disconnected or the
destination memory card is ejected.
❚❚ No Photograph
The camera will skip the current frame if the camera is unable to
focus in AF-S (note that the camera focuses again before each
shot). Shooting will resume with the next frame.
D
Time-Lapse Movies
Time-lapse is not available during live view ( 0 43) or movie recording
( 0 58), at a shutter speed of A or % (0 137) or when bracketing
( 0 146), High Dynamic Range (HDR, 0 191), multiple exposure
( 0 236), or interval timer photography (0 243) is active. Note that
because shutter speed and the time needed to record the image to the
memory card may vary from shot to shot, the interval between a shot
being recorded and the start of the next shot may vary. Shooting will
not begin if a time-lapse movie can not be recorded at current settings
(for example, if the memory card is full, the interval or shooting time is
zero, or the interval is longer than the shooting time).
Shooting may end if camera controls are used or settings are changed
or HDMI cable is connected. A movie will be created from the frames
shot to the point where shooting ended. To end shooting and record
a photograph, press the shutter-release button all the way down.