ProSoft Technology PTQ-101M - Manual (Page 154)

PTQ-101M ♦ Quantum Platform Reference
IEC 60870-5-101 Master Communication Module
Page 154 of 181 ProSoft Technology, Inc.
May 14, 2008
Offset Parameter Description
37 Cmd Resp This word contains the number of command response messages
received on channel 1.
38 Cmd Err This word contains the number of command errors recognized on
channel 1.
39 Requests This word contains the total number of messages transmitted on
channel 1.
40 Responses This word contains the total number of messages received on channel
1.
41 Err Sent This word contains the number of error messages sent on channel 1.
42 Err Received This word contains the number of error messages received on
channel 1.
43 Cfg Err This bit mapped word recognizes any configuration errors for channel
1. Refer to the configuration error word table for a definition of each
bit.
44 Current Error This word contains the error code for the current command executing
on channel 1.
45 Last Error This word contains the error code for the last error recognized on
channel 1.
The following table defines the contents of the configuration error word. Each bit
in the word corresponds to an error condition recognized when the module is
configured. There is a separate word for each application port. This data is
reported in the status data area previously defined.
Bit Code Description
0 0x0001 Invalid baud rate selected
1 0x0002 Invalid parity selected
2 0x0004 Received timeout set to 0
3 0x0008 Invalid Port selected for a session
4 0x0010 Invalid sector count for session
5 0x0020 Could not allocate memory for sector of a session.
6 0x0040 Invalid length data for session:
Data link length
Command address of ASDU length
Information object address length
COT octet count
7 0x0080 Invalid failure delay or confirm timeout for session.
8 0x0100
9 0x0200
10 0x0400
11 0x0800
12 0x1000
13 0x2000
14 0x4000
15 0x8000