ProSoft Technology MVI56-DFCM - Manual (Page 22)

Start Here MVI56-DFCM ♦ ControlLogix Platform
User Manual DF1 Half/Full Duplex Master/Slave Serial Communication Module
Page 22 of 106 ProSoft Technology, Inc.
September 24, 2014
7 You may now use the COM port to connect to the Config/Debug port of the
module.
Note: You may need to shut down and restart your PC before it will allow you to stop the driver
(usually only on Windows NT machines). If you have followed all of the above steps, and it will not
stop the driver, then make sure you do not have RSLogix open. If RSLogix is open, you will not be
able to stop the DF1 driver. If RSLogix is not open, and you still cannot stop the driver, then reboot
your PC.