beautypg.com

Command control blocks – ProSoft Technology MVI56-LTQ User Manual

Page 66

background image

Reference

MVI56-LTQ ♦ ControlLogix Platform

User Manual

Limitorque Valve Actuator Master Communication Module

Page 66 of 98

ProSoft Technology, Inc.

August 30, 2010

Command control blocks are special blocks used to control the module or
request special data from the module. The current version of the software
supports two command control blocks; warm boot and cold boot.

Command Control Blocks

Warm Boot
This block is sent from the ControlLogix processor to the module (output image)
when the module is required to perform a warm-boot (software reset) operation.
The block is commonly sent to the module any time configuration modifications
are made in the controller tags data area. This causes the module to read the
new configuration and restart. The following table shows this structure:

Offset

Description

Length

0

9998

1

1 to 247

Spare

247

Cold Boot
This block is sent from the ControlLogix processor to the module (output image)
when the module is required to perform the cold boot (hardware reset) operation.
This block is sent to the module when a hardware problem is detected by the
ladder logic that requires a hardware reset. The following table describes the
format of the control block.

Offset

Description

Length

0

9999

1

1 to 247

Spare

247