ProSoft Technology MVI56-LTQ - Manual (Page 27)

MVI56-LTQ ♦ ControlLogix Platform Configuring the MVI56-LTQ Module
Limitorque Valve Actuator Master Communication Module User Manual
ProSoft Technology, Inc. Page 27 of 98
August 30, 2010
2.3.13 ActiveSlaves
These 10 words allow the user to configure the specific slaves that are active on
a network. The intent of this table is to allow the user to selectively enable slave
addresses and therefore not have to be concerned about activating slave
addresses continuously.
All values are entered into the table in a right to left order with bit 0 representing
the lower address. The slave addresses are mapped into the table as follows:
Index Description
0
Slaves 1 to 16
1
Slaves 17 to 32
2 Slaves 33 to 48
3 Slaves 49 to 64
4 Slaves 65 to 80
5 Slaves 81 to 96
6 Slaves 97 to 112
7 Slaves 113 to 128
8 Slaves 129 to 144
9 Slaves 145 to 150