beautypg.com

Setting jumpers – ProSoft Technology MVI56-LTQ User Manual

Page 14

background image

Start Here

MVI56-LTQ ♦ ControlLogix Platform

User Manual

Limitorque Valve Actuator Master Communication Module

Page 14 of 98

ProSoft Technology, Inc.

August 30, 2010

1.3

Setting Jumpers

If you use an interface other than RS-232 (default), you must change the jumper
configuration to match the interface. There are three jumpers located at the
bottom of the module.

The following illustration shows the MVI56-LTQ jumper configuration:

1 Set the PRT 2 (for application port 1) and PRT 3 (for application port 2)

jumpers for RS232, RS422, or RS485 to match the wiring needed for your
application. The default jumper setting for both application ports is RS-232.

2 The Setup Jumper acts as "write protection" for the module’s flash memory.

In "write protected" mode, the Setup pins are not connected, and the
module’s firmware cannot be overwritten. Do not jumper the Setup pins
together unless you are directed to do so by ProSoft Technical Support.