ProSoft Technology ILX69-PBS - Manual (Page 27)

ILX69-PBS ♦ CompactLogix or MicroLogix Platform Contents
PROFIBUS Slave Communication Module User Manual
ProSoft Technology, Inc. Page 27 of 102
March 20, 2015
5 Configuration and Start-Up
In This Chapter
 Creating the Module in an RSLogix 5000 Project ..................................27
 Slave Configuration ...............................................................................45
 SD Card .................................................................................................49
This chapter provides descriptions about the configuration and start-up of the ILX69-PBS.
ILX69-PBS Configuration and Parameterization Steps:
The configuration and parameterization of the ILX69-PBS is carried out in three steps:
1 Configuration of the module in a CompactLogix™ project of the Studio 5000 or RSLogix
5000 programming tool.
2 Parameterization and configuration of the ILX69-PBS using the master configuration
software. The slave module can use this configuration during startup.
3 Creating the data objects and the ladder diagram in Studio 5000/RSLogix 5000.
5.1 Creating the Module in an RSLogix 5000 Project
In an RSLogix 5000 project, there are two ways you can add the ILX69-PBS module to the
project.
 You can use an Add-On Profile (AOP) from ProSoft Technology. The AOP contains all
the configuration information needed to add the module to the project. This is the
preferred way, but requires RSLogix version 15 or later.
 You can manually create the module using a generic 1769 profile, and then manually
configure the module parameters. Use this method if you have RSLogix version 14 or
earlier.