ProSoft Technology ILX69-PBS - Manual (Page 24)

Contents ILX69-PBS ♦ CompactLogix or MicroLogix Platform
User Manual PROFIBUS Slave Communication Module
Page 24 of 102 ProSoft Technology, Inc.
March 20, 2015
4.2 ILX69-PBS Hardware Installation
This section describes how to install/uninstall the ILX69- PBS into a CompactLogix™ system.
4.2.1 Safety Precautions
Obey the following property damage messages when installing, uninstalling or replacing the
ILX69-PBS.
Electrostatically sensitive devices

To prevent damage to the PLC and the ILX69-PBS, make sure that the ILX69-PBS is
grounded via the backplane of the PLC. Also make sure that you are discharged when
you install/uninstall the ILX69-PBS.
Device Destruction

Shut off the power supply of the PLC before you install the ILX69-PBS. Then install or
remove the ILX69-PBS to/from the PLC..
 Use only the permissible supply voltage to operate the ILX69-PBS.
 All I/O signal pins at the ILX69-PBS tolerate only the specified signaling voltage.
4.2.2 Installing the ILX69-PBS Module
A detailed description the installation of communication modules in
CompactLogix™ systems can be found in the installation manual for the
1769 CompactLogix™ controller from Rockwell Automation.
1 Install the ILX69-
PBS into a free slot in the CompactLogix™ controller. Make sure it is
within 2 slots of a power supply.
2 Check that the bus lever of the ILX69-PBS is in the unlocked (fully right) position.
3 Assemble the ILX69-
PBS and the CompactLogix™ module together by using the upper
and lower tongue-and-groove slots.
4 Move the ILX69-PBS back along the tongue-and-groove slots until the bus connectors
line up with each other.
5 Move the ILX69-PBS bus lever fully to the left until it clicks. Ensure it is locked firmly in
place.
6 Attach and lock an end cap terminator to the ILX69-PBS by using the tongue-and-groove
slots as before.
7 Apply power to the Rockwell CompactLogix™ controller.