PLANET FPS-1012N User Manual

Page 74

11.The MFP Server will try to determine your network settings. If a DHCP

Server is present, the MFP Server will automatically obtain and

configure the network settings assigned by the DHCP Server. If no
DHCP Server is present, please assign the network settings of the MFP
Server manually. By default, the network settings of the MFP Server in

“Manual IP” selection are as below.

IP Address: 192.168.0.1

Subnet Mask: 255.255.255.0

Please click “Next” once you have found appropriate network settings

for the MFP Server.

Note

The MFP Server IP Address should be in the same network

segment with the connected computer. If the network settings

are incorrect, a message will be prompted to remind you after

you click “Next”. Please make sure that you have set the right

settings before going to the next step. If you don’t want to set

it now, please click “Cancel” to finish the installation. You can

then use the “Server Manager” utility to configure the MFP

Server.