PLANET FPS-1012N User Manual

Page 2

Copyright

part of this publication may be reproduced, transmitted, transcribed,

stored in a retrieval system, or translated into any language or

computer language, in any form or by any means, electronic,

mechanical, magnetic, optical, chemical, manual or otherwise, without

the prior written permission of PLANET.
PLANET makes no representations or warranties, either expressed or

implied, with respect to the contents hereof and specifically disclaims

any warranties, merchantability or fitness for any particular purpose.

Any software described in this manual is sold or licensed "as is".

Should the programs prove defective following their purchase, the buyer

(and not this company, its distributor, or its dealer) assumes the entire

cost of all necessary servicing, repair, and any incidental or

consequential damages resulting from any defect in the software.

Further, this company reserves the right to revise this publication and to

make changes from time to time in the contents hereof without

obligation to notify any person of such revision or changes.
All brand and product names mentioned in this manual are trademarks

and/or registered trademarks of their respective holders.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of FCC Rules. These limits

are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following

measures:

1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

4. Consult the dealer or an experienced radio technician for help.

FCC Caution:

To assure continued compliance.(example-use only shielded interface

cables when connecting to computer or peripheral devices). Any changes

or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject

to the Following two conditions: (1) This device may not cause harmful

interference, and (2) this Device must accept any interference received,

including interference that may cause undesired operation.

Federal Communication Commission (FCC) Radiation Exposure

Statement

This equipment complies with FCC radiation exposure set forth for an

uncontrolled environment. In order to avoid the possibility of exceeding

the FCC radio frequency exposure limits, human proximity to the

antenna shall not be less than 20 cm (8 inches) during normal operation.