PLANET FPS-1012N - Manual (Page 55)

" Note
Before you upgrade the firmware, please make sure that the
IP Address settings of the MFP Server are in the same
network as your computer.
z
Load Default: If you want to reset the MFP Server to default factory
settings, please click “Load Default”.
2.8 Wireless Configuration
If you want to use the MFP Server through wireless LAN, please set up
the MFP Server through Ethernet first and make sure your wireless LAN
setting is correct. After setting the wireless LAN, unplug the Ethernet
cable and restart the MFP Server, then you can start to use the MFP
Server through wireless LAN. If the wireless configuration does not work,
please plug the Ethernet cable again, restart the MFP Server and configure
the MFP Server through Ethernet until the wireless LAN settings are
correct.
The default settings of the MFP Server wireless function are as follows.
z
Mode: Ad Hoc
z
SSID: Default
z
Channel: 11
55