PLANET XRT-501 - Manual (Page 9)

this can be clear ALL data and restore ALL settings to the factory
default values.
WAN Connect your xDSL or Cable modem and is linked to the Internet.
LAN (1-4) Connect your LAN’s PCs, printer servers, hubs and switches etc.
12VDC DC Power in.
1.4 Requirements
DSL or Cable modem for broadband Internet access.
Network cables. Use standard 10/100/1000BaseT network (UTP) cables with RJ45
connectors.
TCP/IP network protocol installed on each PC.
1.5 Physical Installation
Setup your network as shown in the setup diagram below
1. Use standard LAN cables to connect PCs to the Switching Hub ports on the XRT-501,
or you can directly connect PCs to XRT-501, you may use 10Base-T, 100Base-TX, or
1000Base-T connections, and all connection types can be used simultaneously.
2. If required, connect any port to a normal port on another Hub, using a standard LAN
cable. Any LAN port on the XRT-501 will automatically function as an "Uplink" port
when required.
9