PLANET XRT-501 - Manual (Page 26)

Using the XRT-501's DHCP Server
This is the default setting. The DHCP Server settings are on the LAN screen. On this
screen, you can:
Enable or Disable the XRT-501's DHCP Server function.
Set the range of IP Addresses allocated to PCs by the DHCP Server function.
Note
You can assign Fixed IP Addresses to some devices while using DHCP,
provided that the Fixed IP Addresses are NOT within the range used by the
DHCP Server.
Using another DHCP Server
You can only use one DHCP Server per LAN segment. If you wish to use another DHCP
Server, rather than the XRT-501's, the following procedure is required.
Disable the DHCP Server feature in the XRT-501. This setting is on the LAN
screen.
Configure the DHCP Server to provide the XRT-501's IP Address as the
Default Gateway.
To Configure your PCs to use DHCP
This is the default setting for TCP/IP under Windows 98/Me, 2000 or later operating
systems.See 1.6 Configuration for the procedure to check these settings.
2.3 Password
The Password settings function allows you to design password to the XRT-501.
Parameter Description
Current assword
Enter the current password for verification.
Password Type a new password in order to access the Web-Based
26