PLANET ADW-4401 - Manual (Page 67)

The following table describes the parameters and buttons of this page:
Field
Description
IP QoS
Select to enable or disable IP QoS function. You need to enable IP
QoS if you want to configure the parameters of this page.
QoS Policy You can choose stream based, 802.1p based, or DSCP based.
Schedule Mode You can choose strict prior or WFQ (4:3:2:1).
Src IP The IP address of the source data packet.
Src Mask The subnet mask of the source IP address.
Dest IP The IP address of the destination data packet.
Dest Mask The subnet mask of the destination IP address.
Src Port The port of the source data packet.
Dest Port The port of the destination data packet.
Protocol
The protocol responds to the IP QoS rules. You can choose TCP,
UDP, or ICMP.
Phy Port The LAN interface responds to the IP QoS rules.
Set priority
The priority of the IP QoS rules. P0 is the highest priority and P3 is
the lowest.
IP Precedence
You can choose from 0 to 7 define the priority in the ToS of the IP
data packet.
IP ToS
The type of IP ToS for classifying the data package
You can choose Normal Service, Minimize Cost, Maximize
Reliability, Maximize Throughput, or Minimize Delay.
802.1p You can choose from 0 to 7.
delete Select a row in the QoS rule list and click it to delete the row.
delete all Select all the rows in the QoS rule list and click it to delete the rows.
3.6.5 SNMP
Choose Advance > SNMP, the page shown in the following figure appears. You can
configure the SNMP parameters.
67