PLANET ADW-4401 - Manual (Page 42)

The following table describes the parameters and buttons of this page:
Field Description
Protocol
It displays the protocol type used for this WAN
connection.
ATM VCC
The ATM virtual circuit connection assigned for this PPP
interface (VPI/VCI).
Login Name The user name provided by your ISP.
Password The password provided by your ISP.
Authentication
Method
You can choose AUTO, CHAP, or PAP.
Connection Type
You can choose Continuous, Connect on Demand, or
Manual.
Idle Time (s)
If choose Connect on Demand, you need to enter the
idle timeout time. Within the preset minutes, if the router
does not detect the flow of the user continuously, the
router automatically disconnects the PPPoE connection.
Bridge
You can select Bridged Ethernet, Bridged PPPoE, or
Disable Bridge.
AC-Name The accessed equipment type.
Service-Name The service name.
802.1q
You can select Disable or Enable. After enable it, you
need to enter the VLAN ID. The value ranges from 0 to
4095.
Apply Changes Click it to save the settings of this page temporarily.
Return Click it to return to the Channel Configuration page.
Undo Click it to refresh this page.
3.4.2.2 ATM Setting
Click ATM Setting in the left pane, the page shown in the following figure appears. In this
page, you can configure the parameters of the ATM, including QoS, PCR, CDVT, SCR,
and MBS.
42