PLANET ADW-4401 - Manual (Page 30)

1483 Routed
In the Setup WAN Interface page, enter the correct PVC, set the channel mode to 1483
Routed.
The following table describes the parameters of this page:
Field Description
PVC Settings
VPI: Virtual Path Identifier (VPI) is the virtual path between
two points in an ATM network, and its valid value is from 0 to
255.
VCI: Virtual Channel Identifier (VCI) is the virtual channel
between two points in an ATM network, ranging from 32 to
65535 (0 to 31 is reserved for local management of ATM
traffic).
Encapsulation
Select the method of encapsulation provided by your ISP. You
can select LLC/SNAP or VC-Mux.
Channel Mode
Select the WAN connection type. You can select 1483 Bridged,
1483 MER, PPP over Ethernet (PPPoE), PPP over ATM
(PPPoA), or 1483 Routed. In this example, 1483 Routed is
selected.
WAN IP Settings
Obtain an IP address automatically: Obtain the DNS
server assigned by the uplink equipment, such as BAS.
Use the following IP address: Enter the static IP address
provided by your ISP.
Default Route You can select Enable or Disable.
DNS Settings
Obtain DNS Automatically: IP address is assigned by the
office end automatically. You need not to enter the IP
address.
Use the following DNS server address: If you want to enter
the DNS server address manually, select it and enter the
related data.
30