PLANET ADW-4401 - Manual (Page 65)

The following table describes the parameters and buttons of this page:
Field Description
RIP
Select On, the router communicates with other RIP-enabled
devices.
Apply Click it to save the settings of this page.
Interface Choose the router interface that uses RIP.
Recv Version
Choose the interface version that receives RIP messages. You
can choose RIP1, RIP2, or Both.
Choose RIP1 indicates the router receives RIP v1 messages.
Choose RIP2 indicates the router receives RIP v2 messages.
Choose Both indicates the router receives RIP v1 and RIP v2
messages.
Send Version
The working mode for sending RIP messages. You can choose
RIP1 or RIP2.
Choose RIP1 indicates the router broadcasts RIP1 messages
only.
Choose RIP2 indicates the router multicasts RIP2 messages
only.
Add Click it to add the RIP interface to the Rip Config List.
Delete Select a row in the Rip Config List and click it to delete the row.
3.6.3 Port Mapping
Choose Advance > QoS, the page shown in the following figure appears.
65