PLANET ADW-4401 - Manual (Page 64)

The following table describes the parameters and buttons of this page:
Field Description
Enable Select it to use static IP routes.
Destination Enter the IP address of the destination device.
Subnet Mask Enter the subnet mask of the destination device.
Next Hop
Enter the IP address of the next hop in the IP route to the
destination device.
Metric The metric cost for the destination.
Interface The interface for the specified route.
Add Route Click it to add the new static route to the Static Route Table.
Update
Select a row in the Static Route Table and modify the
parameters. Then click it to save the settings temporarily.
Delete Selected
Select a row in the Static Route Table and click it to delete
the row.
Show Routes
Click it, the IP Route Table appears. You can view a list of
destination routes commonly accessed by your network.
Static Route Table A list of the previously configured static IP routes.
Click Show Routes, the page shown in the following figure appears. The table shows a
list of destination routes commonly accessed by your network.
3.6.2.2 RIP
Click RIP in the left pane, the page shown in the following figure appears. If you are using
this device as a RIP-enabled router to communicate with others using Routing Information
Protocol (RIP), enable RIP. This page is used to select the interfaces on your devices that
use RIP, and the version of the protocol used.
64