PLANET ADW-4401 - Manual (Page 27)

1483 MER
In the Setup WAN Interface page, enter the correct PVC, set the channel mode to 1483
MER.
The following table describes the parameters of this page:
Field Description
PVC Settin
l Path Identifier (VPI) is the virtual path between two
gs
points in an ATM network, ranging from 0 to 255.
VCI: Virtual Channel Identifier (VCI) is the virtual channel between
VPI: Virtua
two points in an ATM network, ranging from 32 to 65535 (0 to 31 is
reserved for local management of ATM traffic).
Encapsulation Select the method of encapsulation provided by your ISP. You can
select LLC/SNAP or VC-Mux.
Channel
Mode
Select the WAN connection type. You can select 1483 Bridged, 1483
MER, PPP over Ethernet (PPPoE), PPP over ATM (PPPoA), or 1483
Routed. In this example, 1483 MER is selected.
Default Route You can select Enable or Disable.
DNS Settings
ssigned by the office Obtain DNS Automatically: IP address is a
end automatically. You need not to enter the IP address.
Use the following DNS server address: If you want to enter the
DNS server address manually, select it and enter the IP addresses of
primary DNS and secondary DNS.
27