3 wall mount plate mounting – PLANET IGS-10020HPT User Manual
Page 50
User’s Manual
50
2.2.3 Wall Mount Plate Mounting
To install the Industrial Managed Switch on the wall, please follow the instructions below.
Follow all the DIN-rail installation steps as shown in the example.
Step 1:
Remove the DIN-rail from the Industrial Managed Switch. Use the screwdriver to loosen the screws to remove the
DIN-rail.
Step 2:
Place the wall-mount plate on the rear panel of the Industrial Managed Switch.
Step 3:
Use the screwdriver to screw the wall mount plate on the Industrial Managed Switch.
Step 4:
Use the hook holes at the corners of the wall mount plate to hang the Industrial Managed Switch on the wall.
Step 5:
To remove the wall mount plate, reverse the steps above.
This manual is related to the following products: