beautypg.com

17 mvr status – PLANET IGS-10020HPT User Manual

Page 205

background image

User’s Manual

management VLAN ports.

MVR Name is an optional attribute to indicate the name of the specific MVR

VLAN. Maximum length of the MVR VLAN Name string is 16. MVR VLAN Name

can only contain alphabets or numbers. When the optional MVR VLAN name is

given, it should contain at least one alphabet. MVR VLAN name can be edited for

the existing MVR VLAN entries or it can be added to the new entries.

MVR Name

Define the IPv4 address as source address used in IP header for IGMP control

frames. The default IGMP address is not set (0.0.0.0).

When the IGMP address is not set, system uses IPv4 management address of

the IP interface associated with this VLAN.

When the IPv4 management address is not set, system uses the first available

IPv4 management address. Otherwise, system uses a pre-defined value. By

default, this value will be 192.0.2.1.

IGMP Address

Specify the MVR mode of operation. In Dynamic mode, MVR allows dynamic

MVR membership reports on source ports. In Compatible mode, MVR

membership reports are forbidden on source ports. The default is Dynamic

mode.

Mode

Specify whether the traversed IGMP/MLD control frames will be sent as

Untagged or Tagged with MVR VID. The default is Tagged.

Tagging

Specify how the traversed IGMP/MLD control frames will be sent in prioritized

manner. The default Priority is 0.

Priority

Define the maximun time to wait for IGMP/MLD report memberships on a

receiver port before removing the port from multicast group membership. The

value is in units of tenths of a seconds. The range is from 0 to 31744. The default

LLQI is 5 tenths or one-half second.

LLQI

When the MVR VLAN is created, select the IPMC Profile as the channel filtering

condition for the specific MVR VLAN. Summary about the Interface Channel

Profiling (of the MVR VLAN) will be shown by clicking the view button. Profile

selected for designated interface channel is not allowed to have overlapped

permit group address.

Interface Channel

Setting

Port

The logical port for the settings.

Port Role

Configure an MVR port of the designated MVR VLAN as one of the following

roles.

Inactive

: The designated port does not participate MVR operations.

Source

: Configure uplink ports that receive and send multicast data as

source ports. Subscribers cannot be directly connected to source ports.

Receiver

: Configure a port as a receiver port if it is a subscriber port and

should only receive multicast data. It does not receive data unless it

becomes a member of the multicast group by issuing IGMP/MLD messages.


205

This manual is related to the following products: