PLANET IGS-10020HPT - Manual (Page 45)

User’s Manual
2.1.6 Wiring the Digital Input / Output
The 6-contact terminal block connector on the rear panel of IGS-20040MT is used for Digital Input and Digital Output. Please
follow the steps below to insert wire.
1. The IGS-10020PT/10020HPT/12040MT/20040MT offers two DI and DO groups. 1 and 2 are DI groups; 3 and 4 are DO
groups; and 5 and 6 are GND (ground).
Figure 2-19 Wiring the Redundant Power Inputs
2. Tighten the wire-clamp screws for preventing the wires from loosening.
1 2 3 4 5 6
DI0 DI1 DO0 DO1 GND GND
Figure 2-20 6-Pin Terminal Block DI / DO Wiring Input
45