PLANET MGSD-10080F - Manual (Page 35)

User’s Manual of MGSD-10080F
35
2. INSTALLATION
2.1 Hardware Descriptions
The Managed Switch provides three different running speeds – 10Mbps, 100Mbps and 1000Mbps in the same Switch and
automatically distinguishes the speed of incoming connection. This section describes the hardware features of Managed Switch.
For easier management and control of the Managed Switch, familiarize yourself with its display indicators, and ports. Front
panel illustrations in this chapter display the unit LED indicators. Before connecting any network device to the Managed Switch,
read this chapter carefully.
2.1.1 Front Panel
Figure 2-1 shows a front panel of Managed Switch.
Figure 2-1: MGSD-10080F Switch Front Panel
■ Gigabit TP interface
10/100/1000Base-T Copper, RJ-45 Twist-Pair: Up to 100 meters.
■ Gigabit SFP slots
1000Base-SX/LX mini-GBIC Slot, SFP (Small Factor Pluggable) Transceiver Module: from 550 meters (Multi-mode Fiber),
up to 10/30/50/70/120 kilometers (Single-mode Fiber).
■ Console Port
The console port is a RJ-45 port connector. It is an interface for connecting a terminal directly. Through the console port, it
provides rich diagnostic information including IP Address setting, factory reset, port management, link status and system
setting. Users can use the attached DB9 to RJ-45 console cable in the package and connect to the console port on the
device. After the connection, users can run any terminal emulation program (Hyper Terminal, ProComm Plus, Telix,
Winterm and so on) to enter the startup screen of the device.
■ Reset Button
At the front panel, the reset button is designed for rebooting the Managed Switch without turning off and on the power. The
following is the summary table of reset button functions :