PLANET MGSD-10080F - Manual (Page 215)

User’s Manual of MGSD-10080F
215
Figure 4-9-15: QoS Control List Status Page Screenshot
The page includes the following fields:
Object Description
• User Indicates the QCL user.
•
QCE# Indicates the index of QCE.
•
Frame Type Indicates the type of frame to look for incomming frames. Possible frame types
are:

Any: The QCE will match all frame type.

Ethernet: Only Ethernet frames (with Ether Type 0x600-0xFFFF) are
allowed.

LLC: Only (LLC) frames are allowed.

SNAP: Only (SNAP) frames are allowed.

IPv4: The QCE will match only IPV4 frames.

IPv6: The QCE will match only IPV6 frames.
• Port
Indicates the list of ports configured with the QCE
•
Action Indicates the classification action taken on ingress frame if parameters
configured are matched with the frame's content.
There are three action fields: Class, DPL and DSCP.
 Class: Classified QoS Class; if a frame matches the QCE it will be put
in the queue.

DPL: Drop Precedence Level; if a frame matches the QCE then DP
level will set to value displayed under DPL column.

DSCP: If a frame matches the QCE then DSCP will be classified with
the value displayed under DSCP column.
•
Conflict Displays QCE status. It may happen that resources required to add a QCE may
not available, in that case it shows conflict status as 'Yes', otherwise it is always
'No'.Please note that conflict can be resolved by releaseing the resource required
by the QCE and pressing 'Refresh' button.
Buttons
: Select the QCL status from this drop down list.