Connectors, jumpers, and led’s (sisl), Connectors, jumpers, and led’s (sisl) -19, Figure 2-14 – Avago Technologies AcceleRAID 150 User Manual

Page 33: Table 2-2 to get f

Installation

Manual No. 775020

2-19

Connectors, Jumpers, and LED’s (SISL)

Figure 2-14 is a design example of the AcceleRAID 150 Low Profile
controller.

Figure 2-14. AcceleRAID Connectors, Jumpers, and LED’s

* The LVD and SE lights will not be ON or OFF at the same time.

Table 2-2. AcceleRAID Connectors, Jumpers, and LED Descriptions

Component

Description

JP1

Two-pin header available for connection to a front panel LED
that indicates SCSI activity (user supplied).

JP4

Reserved

JP5

Not used

–

for maintenance only.

JP10

OFF = Disable SISL ON = Enable SISL

Channel 0 Internal Ultra2 SCSI LVD Connector –
68-Pin High Density Cable

Channel 0 External Ultra2 SCSI LVD Connector –
68-Pin Very High Density Cable Interconnect (VHDCI)

LED, ON indicates the controller failed internal diagnostics
during start-up.

LVD (D3)

LED, ON = default; the light is always on unless a single-ended
device is connected. The light will turn OFF when a single-ended
device is detected*.

SE (D2)

LED, ON indicates a single-ended drive is detected.