Avago Technologies AcceleRAID 150 - Manual (Page 17)

Installation
Manual No. 775020 2-3
1. Power OFF the system and any enclosures, such as a tower, and
disconnect the power cord and cables before starting the installation.
Refer to the instructions provided in your system documentation. Do
not disconnect cables or power cords while system power is ON.
2. Read all of the instructions in this chapter completely before proceed-
ing. Follow the Notes, Cautions, and Warnings described in this manual
and marked on the equipment.
3. Safety check the installation before powering ON the system:
• Make sure SCSI cables are properly connected.
• Make sure all SCSI conventions (cable type, cable length,
termination, and SCSI addresses) are followed. Examples of cable
types are: flat, rounded, shielded, or non-shielded – use like types
together.
• For information about cable lengths and formats, please refer to
Table A-1 on page A-1.