Avago Technologies AcceleRAID 150 - Manual (Page 18)

Standard Installation Checklist
2-4 AcceleRAID 150 Installation Guide
Standard Installation Checklist
GET READY
☛
Note
It is recommended that you wear a grounded wrist
strap when working with hardware installation
procedures.
1. ____ Decide which available standard PCI slot will be used.
2. ____ Remove the plate from the I/O access port to the PCI slot.
3. ____ Remove the AcceleRAID 150 controller from the anti-static bag.
4. ____ Check Jumper 10 (JP10). If it is installed on the jumper pins,
remove it according to Figure 2-6.
GET SET
5. ____ Plug the AcceleRAID 150 controller into a standard PCI slot.
6. ____ Tighten the AcceleRAID 150 controller into the mounting
bracket.
7. ____ Connect the SCSI cable(s) drives and/or devices to the controller.
8. ____ Check termination – Only internal or external devices.
9. ____ Check termination – Both internal and external devices.
10. ____ Remove or set termination jumpers to the disabled position on
the disk drive.
11. ____ Set SCSI ID on the disk drive.
12. ____ Enable termination power on disk drives.
13. ____ Safety check the installation.
☛
Note
Review Figure 2-1 and Table 2-1 to get familiar with
the layout of the AcceleRAID 150 controller and the
Connectors, Jumpers, and LED descriptions.
GO
14. ____ Go to Chapter 3, Controller Start-up.