Avago Technologies AcceleRAID 150 - Manual (Page 30)

Before You Begin (SISL)
2-16 AcceleRAID 150 Installation Guide
Before You Begin (SISL)
Installing AcceleRAID PCI to Ultra2 SCSI RAID controller is no more
difficult than installing any PCI adapter. Follow these steps and then follow
the installation procedures in this chapter. Occasionally, you may need to
refer to the instructions that came with your computer system.

WARNING
Disconnect the system from the electrical wall
outlet before opening the system cabinet. Working
with the system covers off and power applied to the
system can result in shock and serious injury.
This controller is furnished with a nonvolatile
RAM (NVRAM) chip that uses a sealed lithium
battery/crystal module. Replace the module only
with the same or equivalent type recommended by
the manufacturer.
Dispose of the used battery/crystal module
according to the manufacturer’s instructions.
Never incinerate a battery as it could explode and
cause serious injury.
1. Power OFF the system and any enclosures, then, disconnect the power
cables before starting the installation. Refer to the instructions provided
in your system documentation. Do not disconnect cables or power
cords while system power is ON.
2. Read all of the instructions in this chapter completely before proceed-
ing. Follow the Notes, Cautions, and Warnings described in this manual
and marked on the equipment.