Avago Technologies AcceleRAID 150 - Manual (Page 16)

Before You Begin (Standard)
2-2 AcceleRAID 150 Installation Guide
Before You Begin (Standard)
Installing a standard AcceleRAID 150 PCI to Ultra2 SCSI RAID controller
is no more difficult than installing any PCI adapter. Follow these steps and
then follow the installation procedures in this chapter. Occasionally, you may
need to refer to the instructions that came with your computer system.

WARNING
Power OFF the system and disconnect the power
cord from the electrical wall outlet before opening
the system cabinet. Working with the system
covers off and power applied to the system can
result in shock and serious injury.

WARNING
This controller is furnished with a nonvolatile
RAM (NVRAM) chip that uses a sealed lithium
battery/crystal module. Replace the module only
with the same or equivalent type recommended by
the manufacturer.
Dispose of the used battery/crystal module
according to the manufacturer’s instructions.
Never incinerate a battery as it could explode and
cause serious injury.