Avago Technologies AcceleRAID 150 - Manual (Page 32)

SISL Installation Checklist
2-18 AcceleRAID 150 Installation Guide
SISL Installation Checklist
GET READY
☛
Note
It is recommended that you wear a grounded wrist
strap when working with hardware installation
procedures.
1. ____ Locate the prewired SISL slot, see your system documentation.
2. ____ Remove the plate from the I/O access port to the SISL PCI slot.
3. ____ Remove the AcceleRAID 150 controller from the anti-static bag.
4. ____ Check Jumper 10 (JP10). If it is not on the jumper pins, install it
to the ON position as shown in Figure 2-19.
GET SET
5. ____ Plug the AcceleRAID 150 controller into the prewired SISL slot.
6. ____ Tighten the AcceleRAID 150 controller into the mounting
bracket.
7. ____ Connect the SCSI cable(s) drives and/or devices to the controller.
8. ____ Check termination for both internal and external configuration.
9. ____ Check termination for embedded system channels.
10. ____ Remove or set termination jumpers to the disabled position on
the disk drive.
11. ____ Set SCSI ID on the disk drive.
12. ____ Enable termination power on the disk drive.
13. ____ Safety check the installation.
☛
Note
Review Figure 2-14 and Table 2-2 to get familiar with
the layout of the AcceleRAID 150 controller and the
Connectors, Jumpers, and LED descriptions.
GO
14. ____ Go to Chapter 3, Controller Start-up.