Enterasys Networks Security Router X-PeditionTM - Manual (Page 432)

System Alarms and Events
A-10 Alarms/Events, System Limits, and Standard ASCII Table
PPP PPP MS-CHAP authentication failed while
being authenticated by remote peer PPP MS-CHAP authentication has failed while being authenticated by
the remote peer.
PPP PPP MS-CHAP authentication success
while authenticating remote peer's
response PPP MS-CHAP authentication has passed while authenticating the
remote peer's response.
PPP PPP MS-CHAP authentication success
while being authenticated by remote peer PPP MS-CHAP authentication has passed while being authenticated
by the remote peer.
PPP PPP PAP authentication failed while
authenticating remote peer PPP PAP authentication has failed while authenticating the remote
peer.
PPP PPP PAP authentication failed while being
authenticated by remote peer PPP PAP authentication has failed while being authenticated by the
remote peer.
PPP PPP PAP authentication success while
authenticating remote peer PPP PAP authentication has passed while authenticating a remote
peer.
PPP PPP PAP authentication success while
being authenticated by remote peer PPP PAP authentication has passed while being authenticated by a
remote peer.
PPP Line protocol on Interface name>, changed state to up A line protocol on an interface comes up.
PPP Line protocol on Interface name>, changed state to down A line protocol on an interface goes down.
PLATF Failed to set syslog rx buf to zero Cannot set recv buffer to zero to discard received syslogs.
ISDN Incoming Call port:channel> Connected to
The incoming call is connected to the shown channel.
ISDN Call
Connected to name> Test call disconnected due to standard ISDN cause. E.g. 16: normal
clearing, 18: user does not answer.
ISDN Call
Disconnected from
Cause CO> The call is disconnected, due to the standard ISDN cause. E.g. 16
normal clearing, 18 User does not answer.
FR Serial a/b:d Config Good Aggregate CIR
nnn less than measured speed+D137
nnnn - CIR Assist is ENABLED Total configured CIR is within 125% of the port measured speed - CIR
assisting is enabled.
ETH0_
DRIV PHY read operation time-out The PHY chip on the FastEthernet 1 port has had an error (other than
time-out) while processing a read request. Port functionality may or
may not be affected: the port is still available, but its functionality may
be diminished. The cause of this alarm is most likely HW failure.
ETH0_
DRIV PHY read operation unsuccessful The PHY chip on the FastEthernet 1 port has had an error (other than
time-out) while processing a read request. Port functionality may or
may not be affected: the port is still available, but its functionality may
be diminished. The cause of this alarm is most likely HW failure.
ETH0_
DRIV PHY write operation time-out The PHY chip on the FastEthernet 1 interface has timed-out while
processing a write request. When this occurs, port functionality may or
may not be affected. The port will still be available, but its functionality
may be diminished. The cause of this alarm is most likely HW failure.
Table A-7 Medium Severity Alarms/Events (continued)
Module Message Description