Enterasys Networks Security Router X-PeditionTM - Manual (Page 250)

Configuring DoD/BoD
10-28 Configuring Dialer Services
XSR(config)#interface dialer 1
XSR(config-if)#encapsulation ppp
XSR(config-if)#ip address 172.22.85.2
XSR(config-if)#ppp pap sent-username XSR-andover password secret 0 dolly
XSR(config-if)#dialer pool 1
XSR(config-if)#dialer string 47410
XSR(config-if)#dialer-group 1
+ Defines interesting packets to trigger dial out
XSR(config-if)#dialer idle-timeout 20
+ Terminates call to Toronto if the line is idle for 20 seconds
XSR(config-if)#no shutdown
The following commands add a dial pool member and set the Central Office switch type on BRI
interface 1/0:
XSR(config)#interface bri 1/0
XSR(config-if)#isdn switch-type basic-net3
XSR(config-if)#dialer pool-member 1
XSR(config-if)#no shutdown
The following command maps ACL 101 to dialer group 1:
XSR(config)#dialer-list 1 protocol ip list 101
The following command defines interesting packets for the dial out trigger by configuring access
list 101 to pass all Type 8 source and destination ICMP traffic up to 20 idle seconds:
XSR(config)#access-list 101 permit icmp any any 8
PPP Point-to-Multipoint Configurations
The following topology can be used for Dial on Demand applications only; it cannot be used for
Dialed Backup applications. Refer to
Figure 10-13 .
Figure 10-13 PPP Point-to-Multipoint Topology
.
XSR-Andover
Switched
line
Switched
line
Switched
line
XSR-Toronto
XSR-Boston XSR-Buffalo
172.22.85.1
172.22.80.4
172.22.85.2 172.22.85.3 172.22.85.4
172.22.95.2 172.22.96.2 172.22.97.2