Enterasys Networks Security Router X-PeditionTM - Manual (Page 206)

Configuring BAP
8-16 Configuring PPP
3. Configure the Dialer 1 interface with a dialer pool:
XSR2(config)#interface Dialer1
XSR2(config-if)#no shutdown
XSR2(config-if)#dialer pool 1
XSR2(config-if)#encapsulation ppp
4. Set up BAP on Dialer 1 by enabling BAP and adding BAP phone numbers for XSR1 to call.
XSR2(config-if)#ppp multilink bap
XSR2(config-if)#ppp bap number default 3101
XSR2(config-if)#ppp bap number default 3102
XSR2(config-if)#ppp bap number default 3103
XSR2(config-if)#ppp bap number default 3104
XSR2(config-if)#ppp bap number default 3105
XSR2(config-if)#ip address 99.99.1.1 255.0.0.0
Dual XSRs: BAP Using Call/Callback Request
The following example sets up BAP between two XSRs, with XSR1 configured to perform Dial on
Demand (DoD) and request additional links by sending a callback request to XSR2, which also is
configured with DoD and requests additional links with call requests to XSR1.
XSR1 Configuration
XSR1(config)#controller e1 2/0
XSR1(config-controller)#pri-group
XSR1(config-controller)#no shutdown
!
XSR1(config)#interface Dialer1
XSR1(config-if)#no shutdown
XSR1(config-if)#dialer pool 1
XSR1(config-if)#encapsulation ppp
XSR1(config-if)#multilink load-threshold 3
XSR1(config-if)#ppp multilink bap
XSR1(config-if)#ppp bap number default 3200
XSR1(config-if)#ppp bap callback request
XSR1(config-if)#dialer-group 2
XSR1(config-if)#dialer map ip 10.10.10.2 1300
XSR1(config-if)#ip address 10.10.10.1 255.255.255.0
XSR1(config)#access-list 102 permit icmp any any 8
XSR1(config)#dialer-list 2 protocol ip list 102
XSR2 Configuration
XSR2(config)#controller e1 2/0
XSR2(config-controller)#pri-group
XSR2(config-controller)#no shutdown
XSR2(config-controller)#dial pool-member 1
XSR1(config)#interface Dialer1
XSR1(config-if)#no shutdown