Configuring vrrp example, Router xsra, Router xsrb – Enterasys Networks Security Router X-PeditionTM User Manual
Page 147: Configuring vrrp example -45, Router xsra -45 router xsrb -45

Configuring VRRP Example
XSR User’s Guide 5-45
XSR(config-if
These commands create the PBR, map it to ACL 101, and set the forwarding router as 192.168.5.2:
XSR(config)#route-map pbr 101
XSR(config-pbr-map)#match ip address 101
XSR(config-pbr-map)#set ip next-hop 192.168.5.2
Configuring VRRP Example
The following example configures three VRRP groups to provide forwarding redundancy and
load balancing on VRRP routers XSRa and XSRb as follows:
•
Group 1: the virtual IP address is 10.10.10.10, XSRa is the group master with priority 120, the
advertising interval is 3 seconds, preemption is enabled with a 2-second delay, and
authentication is set with the text robo.
•
Group 5: XSRb is the group master with priority 200, the virtual IP address is 10.10.10.50, the
advertising interval is 30 seconds, and preemption is enabled with a 2-second delay.
•
Group 100: XSRa is the group master with priority 85, the advertising interval is 1 second
(default), and preemption is off.
•
The WAN Serial interface 2/0 is tracked by FastEthernet interface 1 on each likely master VR.
Router XSRa
XSRa(config)#interface fastethernet 1/0
XSRa(config-if
XSRa(config-if
XSRa(config-if
XSRa(config-if
XSRa(config-if
XSRa(config-if
XSRa(config-if
XSRa(config-if
XSRa(config-if
XSRa(config-if
XSRa(config-if
XSRa(config-if
XSRa(config-if
XSRa(config-if
XSRa(config-if
XSRa(config-if
Router XSRb
XSRb(config)#interface fastethernet 1/0
XSRb(config-if
XSRb(config-if
XSRb(config-if
XSRb(config-if
XSRb(config-if
XSRb(config-if