Enterasys Networks Security Router X-PeditionTM - Manual (Page 279)

More Configuration Examples
XSR User’s Guide 11-15
XSR(config-if)#ip address 1.1.1.3 255.255.255.0
XSR(config-if)#encapsulation frame relay
The following commands add a third, bundled B1/B2 line on BRI interface 0/1/1 and another lease
line on BRI channel 0/1/2:1 with Frame Relay encapsulation. You can add other serial interface
commands as needed.
XSR(config)#interface bri 0/1/1
XSR(config-if)#leased-line bri 0/1/1 144
XSR(config-if)#no shutdown
XSR(config-if)#interface bri 0/1/2:1
XSR(config-if)#ip address 1.1.1.3 255.255.255.0
XSR(config-if)#encapsulation frame relay
More Configuration Examples
The following configuration examples cover T1/E1, PRI and BRI, and lease-line options on the
XSR. For more details on Dialer and Multilink PPP options, refer to
“Configuring Dialer Services”
on page 10-1 and “Configuring PPP” on page 8-1..
T1 PRI
The following example configures a PRI connection on a T1 card:
XSR(config)#controller t1 1/2/3
XSR(config-controller)#pri-group
XSR(config-controller)#isdn switch-type primary-ni
XSR(config-controller)#isdn bchan-number-order descending
XSR(config-controller)#isdn calling-number 915086671234
XSR(config-controller)#no shutdown
E1 PRI
The following example configures a PRI connection on an E1 card:
XSR(config)#controller e1 1/2/2
XSR(config-controller)#pri-group
XSR(config-controller)#isdn switch-type primary-net5
XSR(config-controller)#isdn bchan-number-order descending
XSR(config-controller)#isdn no calling-number
XSR(config-controller)#no shutdown
ISDN BRI
The following example configures a switched line BRI connection:
XSR(config)#interface bri 1/1
XSR(config-if)#isdn switch-type basic-ni1
XSR(config-if)#isdn spid1 2200555 2200
XSR(config-if)#isdn spid2 2201555 2201
Note: ISDN BRI can be configured on XSR 1200 Series routers but only on interface
FastEthernet 0:<1-2>.<1-30>. All BRI examples in this chapter reference Ethernet interfaces
on XSR 1800/3000 Series routers.