Enterasys Networks Security Router X-PeditionTM - Manual (Page 392)

AAA Services
16-6 Configuring Security on the XSR
The method to perform AAA is configured globally by the aaa method command, which provides
additional acct-port , address , attempts , auth-port , backup , client , enable , group , hash
enable , key , qtimeout , retransmit , and timeout sub-commands. Although the default AAA
service is local, you can authenticate to a RADIUS server or PKI database. Alternately, you can set
the AAA method per interface with
aaa-method , which lets the XSR authenticate requests
originating from different interfaces by different methods and overrides the global (invoked by
client ) or default AAA method. For example, if the default method has not been set for Telnet
using client telnet , then the default method you set for AAA service is used.
Most AAA method sub-commands are available for RADIUS service only (see “ Firewall
Configuration for RADIUS Authentication and Accounting ” on page 16-33). Additional AAA
method sub-commands acct-port and auth-port set UDP ports for accounting and
authentication requests, respectively.
AAA users can be added to AAA service with the aaa user command, which includes group , ip
address , password , privilege , and policy sub-commands to set user attributes. Also, you can
set a maximum privilege level per interface to supersede any user/group-assigned level.
While most of these parameters are self-explanatory, the policy value is important in specifying
which system each user will be allowed to access on the XSR. The module options are: firewall ,
ssh , telnet , and vpn . Their intended functions are, as follows:
• Telnet/Console: administrators and low-level Console users who will use the standard serial
connection application
• SSH: users who will require a more secure Telnet-type connection
• Firewall: users who will access the firewall
• VPN: users who will tunnel in to the XSR
AAA users can be assigned to groups with the aaa group top-level command, which is sub-
divided into dns and wins server , ip pool , l2tp and pptp compression , pptp encrypt mppe ,
privilege , and policy sub-commands to set that group’s respective parameters. Any users not
specifically assigned to a group are added to the DEFAULT AAA group. Policies can be set at both
the user and group level but a user-level policy overrides a user’s group-level policy.
Although AAA authentication is set by the service not the user, you can override this rule by
configuring a user to authenticate at every login with
@username . The XSR checks if the
@-configured user is configured before enabling the default authentication service. Refer to the next
section to configure SSH or Telnet with AAA authentication.
Debugging of AAA data can be provided by the debug aaa command. Output is directed to the
terminal where debugging information was most recently requested. Also, if multiple AAA
debugs are activated, all data will be sent to the last used terminal requesting debugging. The
sample AAA debug below displays a successful MSCHAP authentication using the local method:
Local::queue(test)
AAuthenticatePlugin::queue (alg == 0xf)
groupplugin Reply: Pool = authpool
IRMauthorizeMsg::clientLogon [test]
Connecting Remotely via SSH or Telnet with AAA Service
Perform the following commands to configure SSH or Telnet service:
1. On the CLI, enter configure to acquire Configuration mode.