Enterasys Networks Security Router X-PeditionTM User Manual
Page 426
System Alarms and Events
A-4 Alarms/Events, System Limits, and Standard ASCII Table
T1E1
Receiver has Loss of Frame (Yellow
Alarm).
T1/E1 physical port is detecting an OOF alarm.
T1E1
LOF alarm on receiver cleared.
T1/E1 physical port is not detecting an OOF alarm.
T1E1
Transmitting Remote Alarm (Yellow
Alarm).
T1/E1 physical port is transmitting a remote alarm.
T1E1
Transmit Remote Alarm cleared.
T1/E1 physical port is not transmitting a remote alarm.
SYNC_
DRIV
The ISR could not be connected
Driver failed to connect the ISR to the BSP, so it will not start.
SYNC_
DRIV
Init string parse failure
Driver could not parse the initialization string so it will not start.
SYNC_
DRIV
Unrecoverable error
XSR has an un-recoverable error.
SYNC_
DRIV
OS initialization failure
The operating system failed to initialize the driver properly, so the
XSR cannot start.
SYNC_
DRIV
Device not found
XSR could not be found on the PCI bus, so the driver cannot start.
SNMP
Failed to enable SNMP server
Failure to start SNMP server due to failure in the locking mechanism
or the message queue is full.
SNMP
Failed to disable SNMP server
Failure to start SNMP server due to failure in the locking mechanism.
PLATF
System reset from
start
Warm or cold start occurs for the following reasons:
• Default config init: dcfg
• Crash reset: crsh
• CLI reset: cli
• SNMP reset: snmp
• Bootrom reset: btrm
• Software checksum invalid: cksm
PLATF
Failed to initialize sysLog socket
Cannot create socket for sending syslogs.
PLATF
Failed to bind to sysLog port 514
Cannot bind to port 514 for sending syslogs.
ISDN
(CES <1|2)
BRI with a North American switch type successfully registers with the
central office.
ISDN
SME_TERM_REGISTER_ACK
BRI with a North American switch type registers with the central
office but fails.
ISDN
BRI with a North American switch type registers with the central
office and fails. Causes include: 100 - SPID configuration error, 41 -
Network timeout and 1 - Fit timeout
ISDN
%s Layer 2 Terminal %d is DOWN
%s Layer 2 Terminal %d is UP
Q921 - LAP-D status, UP is normal operation. Terminal is 1 for PRI.
For BRI it may be 1 or 2. 1 for ETSI and NTT. For North America 1
and 2 if two SPIDs are configured.
ISDN
%s Outgoing Call to %s %s Timed Out
For basic-NET3 BRI, XSR was unable to activate the BRI line for an
outgoing call.
ISDN
%s Switch Offers call for BUSY channel
%X
Error condition!
Table A-6 High Severity Alarms/Events (continued)
Module
Message
Description