Dial-out router example, Dial-in router example – Enterasys Networks Security Router X-PeditionTM User Manual
Page 251

Configuring DoD/BoD
XSR User’s Guide 10-29
Dial-out Router Example
The following commands add a dialer pool and dialer group, specify a secret password to be sent
to the peer for PAP authentication, and specify three MLPPP call destinations - XSR-Andover,
XSR-Boston and XSR-Buffalo - on XSR-Toronto’s Dialer interface 1. Spoofing is enabled by the
dialer map
command.
XSR(config)#interface dialer 1 multi-point
XSR(config-if
XSR(config-if
XSR(config-if
XSR(config-if
XSR(config-if
XSR(config-if
XSR(config-if
XSR(config-if
XSR(config-if
The following commands add a dialer pool member and set the Central Office switch type on BRI
port 1/0:
XSR(config)#interface bri 1/0
XSR(config-if
XSR(config-if
XSR(config-if
The following command maps ACL 101 to dialer group 1:
XSR(config)#dialer-list 1 protocol ip list 101
The following command defines interesting packets for the dial out trigger by configuring ACL 101
to pass Type 8 source and destination ICMP packets:
XSR(config)#access-list 101 permit icmp any any 8
Dial-in Router Example
The following commands configure Dialer interface 0:
XSR(config)#interface dialer 0
+
Enforces authentication for incoming calls
XSR(config-if
XSR(config-if
The following commands add a dialer pool and specify the PPP authenticated username of XSR-
Toronto calling in to Dialer interface 1:
XSR(config)#interface dialer 1
XSR(config-if
XSR(config-if
XSR(config-if
XSR(config-if
XSR(config-if
The following commands add a dial pool and specifies the PPP authenticated username XSR-
Boston to map incoming calls to Dialer interface 2:
XSR(config)#interface dialer 2
XSR(config-if
XSR(config-if
XSR(config-if