Setting energy saver function, Setting energy saver function -20, Tion see – TA Triumph-Adler 2256 User Manual
Page 48: Sleep and sleep timer
2-20
Installing and Setting up the Machine > Default Settings of the Machine
Setting Energy Saver Function
To use the Energy Saver function, configure the following settings:
•
Sleep and Sleep Timer (page 2-20)
•
Sleep and Sleep Timer
Sleep
To enter Sleep, press the [
Energy Saver
] key. All indicators on the operation panel will go out to save power except the
[
Energy Saver
] indicators. This status is referred to as Sleep.
If print data is received during Sleep, the print job is performed while the message display remains unlit.
When using the optional FAX, received fax data is printed out while the message display also remains unlit.
To use the machine, press any key on the operation panel.
The machine will be ready to operate within 11 seconds.
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
Sleep Timer
Sleep Timer automatically switches the machine into Sleep if left idle for a preset time.
The default preset time is 1 minute.
To change the preset sleep time, refer to
Follow the steps below to set the sleep timer for the machine to go into sleep mode when not in use.
1
Display the screen.
1
Press the [
Status/System Menu/Counter
] key.
2
Press the [
▲
] or [
▼
] key to select [Common Settings], and press the [
OK
] key.
2
1
Status/Sys. Menu:
System
Exit
04
Admin/Accounting
05
Common Settings
06