RIGOL DS1000B - Manual (Page 19)

RIGOL
User’s Guide for DS1000B Series 1-7
Functional Check
Perform this quick functional check to verify that the instrument is operating
correctly.
1. Turn on the instrument
Use the power cord designed for the oscilloscope only to connect the instrument
and AC power which delivers 100 to 240 VAC
RMS
, 45Hz to 440Hz. Press the
power switch to turn on the instruments, waiting until the display shows the
waveform window.
2. Recall factory setting
Press Storage → Storage → Factory → Recall, to recall factory setting.
Figure 1-4 Button explanation
WARNING
To avoid electric shock, be sure the oscilloscope is properly grounded.
3. Input a signal to a channel of the oscilloscope
 Push BNC plug of probe into CH1 BNC connector, then twist the BNC cable to
right to lock the probe in place. Switch on the probe to 10X [1] .
 Press CH1 → Probe → 10X to set probe attenuation of the oscilloscope, so as to
make sure the measurement result is correct (Default probe attenuation scale is
1X).
Storage Button
Power
Switch
!