Precision Digital PD6000 - Manual (Page 29)

Model PD6000 Analog Input Process Meter Instruction Manual
29
Display Parameter Action/Setting Description
ignore Ignore Ignore loop break condition
(Processed as a low signal condition)
On On Relay goes to alarm condition when loop
break is detected
Off
Off Relay goes to non-alarm condition when
loop break is detected
Aout Analog output Enter the Analog output scaling menu
Dis 1 Display 1 Program display 1 value
Out 1 Output 1 Program output 1 value (e.g. 4.000 mA)
Dis 2 Display 2 Program display 2 value
Out 2 Output 2 Program output 2 value (e.g. 20.000 mA)
prog Program Enter the Program menu
SCALE
Scale Enter the Scale menu
SCAL 1
Scale 1 Enter the Scale menu for PV1
SCAL 2
Scale 2 Enter the Scale menu for PV2
Cal
Calibrate Enter the Calibration menu
Inp 1
Input 1 Calibrate input 1 signal or program input 1
value
Dis 1 Display 1 Program display 1 value
Inp 2 Input 2 Calibrate input 2 signal or program input 2
value (up to 32 points)
Dis 2 Display 2 Program display 2 value (up to 32 points)
Error Error Error, calibration not successful, check
signal or programmed value
pass
Password Enter the Password menu
Pass 1
Password 1 Set or enter Password 1
Pass 2
Password 2 Set or enter Password 2
Pass 3 Password 3 Set or enter Password 3
unloc Unlocked Program password to lock meter
locd Locked Enter password to unlock meter
999999
-99999 Flashing Over/under range condition