MCZ PowerTherm - Manual (Page 43)

PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL page 43
Operation Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
Once you have selected programme P99 press push button 4 to enter
daily programming mode. The first day of the week will start flashing
(MO = Monday).
Use key 5 to scroll the programmes from 01 to 60 and select the
desired one, after consulting the table in
paragraph 4.12. When you
carry out this type of programming, you will notice that the 24 h icon
also lights up to show that daily rather than weekly programming is
being performed.
Once the desired programme has been selected for the active day
(E.g.: 32 for the day MO = Monday), again pres button 4 to proceed
with programming of the day TU = Tuesday). Notice that as soon as
the day MO = Monday is confirmed, under MO a dash appears to
indicate that a daily programme is active for that day.
As soon as the daily programme is confirmed with the key 4, the remote
control moves to the next day. Repeat the setting operations described
above for all the days of the week.
If for a given day of the week you do not want to set any
programme, select programme 00 and continue with
programming. Notice that under that day there is no dash.
Upon completion of programming, press button 6 or wait 30
seconds and the remote control will automatically exit the menu,
confirming the selections you have made.
If a timer programme is active but the user decides
to start/stop the stove in advance, the command
given by the user overrides the timer and is carried
out. The next command from the timer is obviously
disregarded.
Example: if the timer calls for the stove to be started
up at 10:00 but the user decides to start it
at 9:00, by pressing button 5 the stove will
come on. At 10:00, the timer, which was
to order start-up, will be disregarded.
The setting defined on the personalised programme
is stored in the memory even if the batteries of the
remote control are removed and replaced.
IMPORTANT NOTE
It takes 10 to 15 minutes for the stove to start up, and
another 10 to 15 minutes before sufficiently hot air comes
out.
Take this into account when setting the start time. Likewise,
stove shutdown requires about 30 minutes, during which the
heat stored up by the stove is still released into the room.
Keep this in mind for substantial fuel savings.
PROGRAM
24 h
PROGRAM
24 h